Unitech MS920

130
•
••
•Good read beeps
•
••
•Number
- "Normal" bar codes: 1 beep (default) = good read
- Configuration codes: 2 beeps = good read, 6 beeps = setup error,
3 long beeps = EEPROM integrity error (contact your Intermec
representative !).
Beeps / LEDs - Good read beeps - Number - 1 beep (*)
<SW>724101
Beeps / LEDs - Good read beeps - Number - 2 beeps
<SW>724102
Beeps / LEDs - Good read beeps - Number - None
<SW>724100
•
••
•Duration
- Value is in milliseconds
Beeps / LEDs - Good read beeps - Duration - 60
<SW>7281003C
Beeps / LEDs - Good read beeps - Duration - 80 (*)
<SW>72810050