•
••
•Length mode
- L1 = Codes with as many characters as specified by L1 and longer are read
(L2 and L3 are not used).
- L2 = Only codes that comply with the lengths specified by L1, L2, and L3 will
be read.
- L3 = Codes at least the length specified by L1 and no longer than the
maximum length specified by L2 are read (L3 is not used).
Code 11 - Barcode length - Length mode - L1 as Minimal length (*)
<SW>4A5300
Code 11 - Barcode length - Length mode - L1, L2, L3 as fixed length
<SW>4A5301
Code 11 - Barcode length - Length mode - L1 as min, L2 as max
<SW>4A5302
•
••
•Set length L1, L2 and L3
- Set barcode length L1, L2 and L3 according to the barcode length mode
used.
•
••
•Code 39
- Alphanumeric symbology.
- Letter case not defined - transmitted in upper case.
- Format: standard 43 characters (default) or full ASCII (see "format" for lists).
Code 39 - Disable
To Next Page
Loading...
