Unitech MS920

86
<SW>414844
•
••
•Barcode length
- Use the L1 as minimum length option if you know the minimum length of the
codes in your application!!!
- To optimize decoding performance and increase security, select the same
length as the minimum length in your application (do not select a shorter
length!!).
Length = [barcode data]
- Minimum length possible = 1 character.
•
••
•Length mode
- L1 = Codes with as many characters as specified by L1 and longer are read
(L2 and L3 are not used).
- L2 = Only codes that comply with the lengths specified by L1, L2, and L3 will
be read.
- L3 = Codes at least the length specified by L1 and no longer than the
maximum length specified by L2 are read (L3 is not used).
Code 93 / Code 93i - Barcode length - Length mode - L1 as Minimal length (*)
<SW>415300
Code 93 / Code 93i - Barcode length - Length mode - L1, L2, L3 as fixed length
<SW>415301
Code 93 / Code 93i - Barcode length - Length mode - L1 as min, L2 as max
<SW>415302