OX Amp Top Box OX Software App 24
App Views
The app has three main view screens: RIG, ASSIGN, and SETTINGS. Each view contains
the settings related to these functions.
RIG – Rig settings are adjusted in Rig view. Every sonic setting that changes the tone of
an individual Rig is contained within this view. Individual Rig presets are also managed
in this view.
ASSIGN – Individual Rigs and Rig Sets are assigned to OX’s RIG knob slots in Assign
view.
SETTINGS – OX’s Wi-Fi networking settings and global system settings are accessed in
Settings view. A link to UA’s OX Knowledge Base is available here for technical support.
Choosing App Views
To display any app view, select its view name at the top right of any app view.
Tip: The name of the active view is highlighted in amber.
App view selectors with RIG view active
Terms
Specific terms are used in this chapter when describing the various OX component
functions. These terms are defined below.
OX – The self-contained OX hardware unit. OX does not refer to the OX software app or
the Mac/iPac device unless specifically noted otherwise.
App – OX’s remote control software application.
Rig – One complete guitar tone that contains the settings of all available sonic controls.
Rig Set – A collection of six individual Rigs that can be quickly assigned to OX’s RIG knob.
Effect(s) – OX’s four independent effect processors (EQ, compression, delay, and reverb).
Preset – One complete set control values stored within OX. OX has Rig presets and effect
presets. Presets are loaded, saved and renamed in the Presets Manager.
To Next Page
Loading...
Need help?
General
