UAD Powered Plug-Ins Manual - 69 - Chapter 6: UAD Meter & Control Panel
Plug-In Column All currently installed UAD Powered Plug-Ins are displayed in the Plug-In col-
umn. Use the scrollbar to view the entire list if necessary.
Status Column The Status column reflects the current state of each UAD plug-in. The status de-
pends on which device (UAD-2 or UAD-1) the plug-in is running on; the status
may change if the “Run On” device is changed (page 71). After the authori-
zation file is loaded (“Authorization Over
view” on page 48), the status will
show one of the following:
Authorized for all devices
The plug-in is fully licensed and authorized to run on all devices in the system.
Start Demo
The demo period has not been started for the plug-in. Click the “START
DEMO” button to begin the 14-day trial period.
Demo (days remaining)
If the14-day trial period has been activated but is not yet expired, the number
of days remaining is displayed here in green text.
Important: The 14-day demo period can only be activated once, and can-
not be stopped or restarted during this period! We recommend you do not ac-
tivate demo mode until you have the time to thoroughly check out its sound
and functionality. See “Demo Mode” on page 51 for detailed information.
Not available for UAD-2
The plug-in has not been ported to the UAD-2 and is available to run on
UAD–1 devices only. In this case, the Run On menu is unavailable.
No UAD-1 devices found
This is displayed for non-ported UAD-1 plug-ins when both device types were
selected during software installation, but only the UAD-2 is currently installed.
In this case, the Run On menu is unavailable.
To Next Page
Loading...
Need help?
General
