6.2.11. Export From Robot Tab
The Export from Robot tab allows you to create and export the Support File from your connected
robot via ethernet connection to the computer. Refer to 2.5.5 Record Data tab topic in this manual,
to understand how to connect the robot’s and computer IP addresses.
For older robot software versions (PolyScope 5.7 and 3.12 below) the Log History and Flight
Reports are retrieved instead of the Support File.
After the download the user will be asked, if he/she wants to open the pulled data directly on UR
Log Viewer or just store in the computer.
e-Series 90 Service Manual
6.Troubleshooting
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
