Universal M-35B(C) User Manual

DC ELECTRICAL SYSTEM WIRING DIAGRAM ·#39144
r-----
~~~~*
I I
I
I .J
I
I
I
+~
AAlliJI:L
.110m
Use !l-electrfc gmase tin lh• wiring connections •1
lllllen m~tlle ilsfroll!flllt panel ham.ss fo ~ =.::....:~
engne hllmess. 11lerr l)<wnrp ~ plJgs together
Ill ilnWIII a tight n1 sacure oonnec/lcn.
r--
Ill ILK
Ill 11.11:
Ill BLK
tit I!ILII
··m •
+ ALAIN
C IUlZEI
-I
. , .. , ..
ADMIRAL
PANEL
CAPTAIN
PANEL
,
I
4
4
Unlvarsal
MARINE POWER
23
These diagrams illustrate the 12 volt negative ground
electrical circuit. The two optional instrument panels,
the CAPTAIN PANEL and the ADMIRAL PANEL are
diagramed below .
When an ADMIRAL PANEL is installed, two additional
instrument sendors are assembled to the engine to
provide data for the panel gauges (refer to the illustra-
tions below).
REMOVE THE PLUG AND SCREW
IN THE SENDER
\)
THERMOSTAT
HOUSING
~
PLUG
ATTACH THE SPARE WIRE
FROM THE HARNESS BUNDLE
(co/orcodedyeflow) ·
REMOVE THE PLUG AND
INSTALL THE OIL TEMP. SENDER
NOTE: ® Denotes oil pressure afann circuit resister PN039806
off the preheat sofenoi~ ·I • tenninal
* NOTE: An on-off switch
should be installed in this
circuit to disconnect the
starter from the battery in
an emergency and when
leaving the boat. Twelve
volt diesel engine starters
typically draw 200 to 300
amps when cranking. A
switch with a continuous
rating of 175 amps at 12
VDC will normally serve
this function, but a switch
must never be used to
"make" the starter circuit.

Universal M-35B(C) Specifications

General

Brand	Universal
Model	M-35B(C)
Category	Engine
Language	English