Universal M-35B(C) User Manual

HURTH HBW/ZF TRANSMISSION TROUBLESHOOTING
Problem
Probable Cause
Verification/Remedy
High fluid temperature. 1.
Fluid level high during operation. 1.
Pump out fluid to the maximum and mark on dipstick.
2. Fluid level low. 2. Add fluid.
3.
Plugged or restricted fluid cooler.
3. Replace cooler and flush water system.
4. No water in cooling system. 4. Check cooling system and repair.
5.
Riter clogged (if applicable).
5.
Replace element.
Fluid on transmission housing.
1. Loose screws. 1. Tighten to specification.
2. Loose screw connections. 2. Tighten, replace.
3. Loose dipstick. 3.
Tighten, replace.
4.
Loose fluid filter. 4. Tighten, replace.
5.
Ruid level high during operation. 5. Pump out fluid to the maximum and mark on dipstick.
Fluid and water mixed; shifts hard. 1.
Damage to fluid cooler .. 1.
Replace cooler and flush transmission and hoses.
. 2. Selector control linkage. 2. Refer this manual.
Slow engagement. 1.
Selector control. 1. Refer this manual.
2.
Low fluid level. 2. Add fluid.
3.
Linkage. 3. Adjust (refer this manual.
No movement of the boat. 1.
Selector control. 1. Consult service station.
2.
Improper selector position. 2. Adjust (see this manual).
3.
Low fluid level. 3. Add fluid.
4. Propeller missing.
4. Replace.
5. Propeller shaft broken. 5. Contact marine repair.
6. ·Transmission malfunction.
6. Contact manufacturer.
7. Engine malfunction. 7. Contact marine repair.
.
NOTE: If you suspect a major problem in your transmission, immediately contact your WESTERBEKE dealer or an authorized
marine transmission facility.
+ · .unlvarsal
MARINE POWER
41

Universal M-35B(C) Specifications

General

Brand	Universal
Model	M-35B(C)
Category	Engine
Language	English