UP3D ACUBLU - Page 36

UP3D TECH CO.,LTD
36
（4）【Select the scanning area】
Function: Set the scan height and scan area
Operation:-Click
【
Front View
】
, Keep pressing the mouse left button , then drag the red
arrow up and down, the area below the arrow will not be scanned.
-Click
【
Vertical view
】
Click the left button on the model then select the scanning area;
Zoom in and out the selected area with the mouse wheel
Click the right button can delete the selected area.
Click 【YES】,scan the selected area.
Click 【Cancel】,Scan the whole area.
（5）【Axis initialization】
Function: The scanner rotating and swing axis return to their original position (return to zero)
Operation: Click【Axis initialization】
（6）
【
Add scan
】
Function: Add scan of the model area that is not scanned comprehensively
Operation: Rotate the model to the angle that needs to add scan and double click the left
button to view the add scan area after you determined scan angle.
Click the 【Add scan】button or press 【Space】. The main scene has an orange color to be
displayed on the model after add scan completed.
（7）【Apply】
Function: post-processing of scanned data
Operation: Click
【
Apply
】
after the re-scan or add scan are completed. (This button is
only displayed after scanning, such as re-scan ,add scan and before data processing.)
（8）【Remark】
Function: Cancel all marked teeth and remark
Operation: Click【Remark】（This button is only displayed in the step of marking the
teeth
）