UP3D ACUBLU - Implant Scan Body Scanning

UP3D TECH CO.,LTD
57
A2. Click
【
Next
】
/
【
Enter
】
to scan;
A3. Check if it needs to add scan after the impression is scanned (editable),if not, click【Apply】
(4) Automatic alignment: occlusion alignment
(5) The order scanning is finished
4.4.4 Implant scan body scanning
4.4.4.1 Gypsum, scan body, with ginginva
Application: For orders that need to scan the scan body for implant
（1）
Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: model
Occlusion: none
Adjacent tooth scan: sectioned or unsectioned
Implant type: customized abutment
Gingiva scan: yes
（2）Jaw scan
A1. Follow the instructions of the scanning guide then insert the jaw model
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the model is scanned (editable),if not, click【Apply】
（3）Scan body scan
A1. Follow the instructions of the scanning guide then put the scan body on the model
A2.Click
【
Next
】
/
【
Enter
】
to scan;
A3.Check if it needs to add scan after the scan body model is scanned (editable),if not, click
【Apply】
（4）
Gingiva scan
A1. Follow the instructions of the scanning guide then insert the gingiva on the model
A2. Click
【
Next
】
/
【
Enter
】
to scan;
A3. Check if it needs to add scan after the gingiva model is scanned (editable),if not, click
【Apply】
(5) Automatic alignment including: scan body and gingiva alignment