Function: If you do not use die plate to scan the die and there is die scan data, then the die
scan data would be deleted. If there is no die scan data, then delete the current die batch.
Operation: Click【Delete batch】(This button is only displayed when the die plate in
scanning die step is not used.)
（10）
【
Reset all
】
Function: Cancel the result of automatic alignment and perform manual alignment
Operation: Click
【
Reset all
】
（11）
【
Reset current
】
Function: The alignment point is revoked when aligning manually
Operation: If the point position is selected incorrectly when one point is aligned, click the
【
Reset current
】
button, undo the point and then re-select the point position.(Or if not use this
button, you can directly drag move the point to another location.)
If the point position is selected incorrectly when three points are aligned, click the
【
Reset current
】
button, undo these points and then re-select the points position.(Or double-click the point and delete
it then re-select the point position)
（12）【Align】
Function: Apply current manual alignment;
Operation: Click【Align】
（13）【Export】
Function: Export scan data
Operation: Click【Export】
4.3.2 Tools
The tools includes: view tools, 2D sections, model editing tools, and margin detecting tools.
Among them, the model editing tools include: selection tool, hole filling tool, invert,
undo/redo.
To Next Page
Loading...
