UP3D ACUBLU - Scanning Procedures; Multi-dies Scanning

UP3D TECH CO.,LTD
46
4.4 Scanning step
Start scanning
 Create an order in UPDentalManager and start scanning;

Create an order in EXO and start scanning;
The scanning step varies with specific conditions, mainly including the following conditions:
 Order settings (ie,model type [gypsum model, impression model], if there is antagonist jaw,
sectioned, use multi-dies plate or not, etc.)
 UPSCAN settings (ie, if use texture, scan the occlusion relationship at first or not,etc.)
4.4.1 Multi-dies scanning
Application:
For single or multiple dies, no need for occlusion and adjacent tooth scans
Steps:
Create orders, follow the instructions for die scanning
4.4.1.1 Create orders
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning.
Model source: Model.
Adjacent teeth: None (ie: use multi-dies plate)