UP3D ACUBLU - Wax-up Scanning

UP3D TECH CO.,LTD
58
(6) The order scanning is finished
4.4.5 Wax-up scanning
4.4.5.1 Gypsum model, sectioned, single wax-up (take no antagonist for example)
（1）
Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: model
Occlusion: none
Adjacent tooth scan: sectioned model
（2）Model scan
A1. Follow the instructions of the scanning guide then insert the model
A2. Click
【
Next
】
/
【
Enter
】
to scan;
A3. Check if it needs to add scan after the model is scanned (editable),if not, click【Apply】
（3）Die scanning
A1. Follow the instructions of the scanning guide then insert the dies
A2. Click
【
Next
】
/
【
Enter
】
to scan;
A3. Check if it needs to add scan after the dies is scanned (editable),if not, click【Apply】
（4）Single wax-up scan (Use the multi-dies plate )
A1. Follow the instructions of the scanning guide then insert the wax-up
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the wax model is scanned(editable),if not, click【Apply】
(5) Automatic alignment including: die and wax-up alignment
(6) The order scanning is finished
4.4.5.2 Gypsum model, sectioned, wax-up bridge (take no antagonist for example)
（1）
Create an order
A1.Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Design type: wax-up (whether bridge or not)
Model source: model