UP3D ACUBLU - Impression Scanning

UP3D TECH CO.,LTD
54
A3. Check if it needs to add scan after the occlusion model is scanned (editable),if not, click
【
Apply
】
.
（3）All-in-one scanning
A1.Follow the instruction of the scanning guide to put in a quadrant model (upper jaw and lower
jaw)
A2.Click
【
Next
】
/
【
Enter
】
to scan;
A3.Check if it needs to add scan after the quadrant dental model scan is completed (editable),if not,
click
【
Apply
】
(4) Model occlusion automatic alignment
(5) The order scanning is finished
4.4.3 Impression scan
4.4.3.1 Single side impression scan (antagonist: opposite tray)
Application: For scanning impressions that have not been turned into gypsum
（1）
Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: impression
Impression tray: single side
Occlusion: opposite tray.
（2）Impression tray scanning (working model)
A1. Follow the instructions of the scanning guide then insert the working impression tray
A2.Click
【
Next
】
/
【
Enter
】
to scan;
A3.Check if it needs to add scan after the working impression tray is scanned (editable),if not,
click【Apply】
（3）
Opposite tray scanning (non-working model)
A1. Follow the instructions of the scanning guide then insert the non-working impression tray
A2.Click
【
Next
】
/
【
Enter
】
to scan;
A3.Check if it needs to add scan after the non-working impression tray is scanned (editable),if not,
click【Apply】
(4)Manual alignment: occlusion alignment
(5)The order scanning is finished