UP3D ACUBLU - Page 55

UP3D TECH CO.,LTD
55
4.4.3.2 Single side impression scan (antagonist: opposite tray + wax-bite)
Application: For scanning impressions that have not been turned into gypsum.
（1）Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: impression
Impression tray: single side
Occlusion: opposite tray+wax-bite
（2）Wax-bite scan
A1. Follow the instructions of the scanning guide then insert the wax-bite
A2. Click【Next】/【Enter】to scan
A3. Check if it needs to add scan after the wax-bite is scanned (editable),if not, click
【
Apply
】
（3）Impression scan (working model)
A1. Follow the instructions of the scanning guide then insert the working impression model
A2. Click
【
Next
】
/
【
Enter
】
to scan
A3. Check if it needs to add scan after the working impression model is scanned (editable),if not,
click
【
Apply
】
（4）Opposite tray scan (non-working model)
A1. Follow the instructions of the scanning guide then insert the non-working opposite tray model
A2. Click
【
Next
】
/
【
Enter
】
to scan;
A3.Check if it needs to add scan after the non-working opposite tray model is scanned (editable),if
not, click【Apply】
(5) Manual alignment: occlusion alignment
(6) The order scanning is finished
4.4.3.3 Triple tray impression scanning (Full arch, place it horizontally)
Application: For scanning impressions that have not been turned into gypsum and the arch is a bit
long.
（1）
Create an order
A1. Create an order, select the tooth position and define a design type
The impression automatically performs the invert in the export step.