Manual Connect Box
14
E
Check that you have the required cables, adapters, and adapter software. Verify that the
proper drivers are installed for the Ethernet adapter on each networked computer. For
information on WLAN setup, see Setting Up Your Wireless LAN.
System Requirements
Your computer must meet the following minimum requirements:
Computer with Pentium© class or better processor
Windows XP, Windows 7, Windows 8, Macintosh, or UNIX operating system with
available operating system CD-ROM
Any web browser, such as Microsoft Internet Explorer, Netscape Navigator®,
or Mozilla® Firefox®
Connecting the Connect Box
Before starting, be sure the computer is turned on and the Connect Box power cord is
unplugged.
1. Connect one end of the coaxial cable to the cable outlet or splitter.
2. Connect the other end of the coaxial cable to the Cable connector on the Connect
Box. Hand-tighten the connectors to avoid damaging them.
3. Plug the power cord into the Power port on the Connect Box.
4. Plug the other end of the power cord into an electrical wall outlet.This automatically
powers on the gateway. You do not need to unplug the gateway when it is not in use.
The first time you plug in the Connect Box, allow it 5 to 30 minutes to find and lock
on the appropriate communications channels.
5. Plug the other end of the telephone cord of a single or two-line telephone into the
TEL 1/2 port on the rear of the Connect Box.
6. Plug the telephone cord of a single or two-line telephone into the telephone.
7. Connect the Ethernet cable to the Ethernet port on the computer, and connect the
other end of the Ethernet cable to the Ethernet port on the gateway.
E
To Next Page
Loading...