Installation Guide for Uplogix Local Managers 25
For each setting, you can accept the default or existing setting by pressing the enter key.
1. Press the enter key on the keypad to access the menu. The > character appears to the
left of the currently selected option. Press enter or the right arrow button to access the
configuration screens.
>Configure
Restart
2. The Local Manager can use a DHCP server for network addressing. Brackets appear
around the selected option. Use the left and right arrows to select your response and
press enter to advance. If you are using DHCP, press the enter key and skip to Step 6.
You can review the assigned IP address after configuration is complete by re-entering
the configuration dialog.
Use DHCP?
[Yes] No
3. If you choose not to use DHCP, enter the IP address that the Local Manager should
use. Use the left and right arrows to move between digits of the IP address, and the
up and down arrows to change individual digits. The > prompt points to the digit to be
changed.
IP Address:
>000.000.000.000
When entering an IP address, built-in validation keeps the octet below 255 at all
times. You may need to change the second digit before you can change the first digit.
For example, to change the number 180 to 240, you must change the second digit
from 8 to 4 before you can change the first digit from 1 to 2. The validation will not
allow an address 280, so the first character will toggle between 1 and 0 until you
change the second character to keep the octet at or below 255.
4. Configure the Local Manager’s subnet mask in the same manner:
Netmask:
>255.255.255.000
5. Specify a default route for network connectivity.
Default Route:
>000.000.000.000
6. Whether you use DHCP or a static IP address, the Local Manager next prompts you to
select speed and duplex options for the management Ethernet connection.
Speed/Duplex
<auto>
Autonegotiation is the default setting. If you choose not to use autonegotiation, select
speed and duplexing to match your network.
Speed/Duplex
<auto>
Use the right arrow key to view other speed/duplex options. They appear as 1000full,
100full, 10full, 100half and 10half.
This setting needs to match the speed and duplex setting on the switch port that is
connected to your Local Manager.
To Next Page
