28 29
BASE INSTALLATION WITH LOWER ANCHORS – Safety Check
Base doesn’t move more than 1" side-to-side and front-to-back at the belt path.
Lower anchor connector webbing is secure and untwisted.
Ensure tightness indicator is GREEN after each use. If it is not, apply pressure
by pushing base into seat bight (crease of seat) to tighten.
Recline angle is correct. Check the level angle indicator on base to ensure
the bubble is still within the lines. NO partial bubble allowed.
Make sure the load leg is secured and contacts the vehicle floor. Check that the
load leg angle indicator is GREEN. Any RED showing indicates that the load leg
is not properly level with the vehicle floor. Always store the load leg under base
when not in use.
ALL STEPS MUST BE COMPLETE.
If not, return to pg 24 and start over.
BASE INSTALLATION WITH LOWER ANCHORS – Safety Check
To Next Page
Loading...
