38 39
CONTINUE IF USING PREFERRED LOAD LEG INSTALLATION
INSTALLING LOAD LEG
1 After the base is secured, rotate load leg
extension until its showing fully green.
2 Using two hands, separate the two ends to
remove any RED showing.
NOTE: After installing the load leg, check
the level angle indicator on base to ensure
the bubble is still within the lines.
REVIEW SAFETY CHECK ON PAGE 40.
All steps must be achieved.
WHAT IS A WATERFALL?
Many late model vehicles have what industry professionals call a waterfall.
A waterfall is the wedge of material where your vehicle seat cushion and seat
back meet. In some cases, this may prevent the Anti-Rebound+ Panel from
making full contact with the vehicle seat back.
This is an easy issue to resolve by following the steps below:
1 Uninstall your MESA MAX base.
2 Adjust the level adjustment foot to achieve proper recline level.
3 Push the base into the seat back. If there is a gap between the top of the MESA
MAX base and the back of the vehicle seat, place a rolled hand towel in the gap flush
with the top of the base.
4 Proceed to BASE INSTALLATION WITH VEHICLE SEAT BELT (pg 34 or 36)
based on your method of installation). Follow Safety Check (pg 40) to confirm proper
installation.
BASE INSTALLATION WITH VEHICLE SEAT BELT BASE INSTALLATION WITH VEHICLE SEAT BELT
1
2
To Next Page
Loading...
Need help?
General
