50 51
CARRIER INSTALLATION WITH VEHICLE SEAT BELT
Lap Belt Only Routing Method
1 Route the lap belt through both guides on the carrier, and buckle the seat belt.
2 Push the carrier into the vehicle seat bight (crease of the seat) and gently apply
pressure from behind the carrier into the vehicle seat back. At the same time,
pull on the loose portion of the lap belt closet to the buckle.
NOTE: Be mindful of canopy
3 Rotate carry handle forward to the (4th) rebound position when in use.
NOTE: Check that the carrier is still properly leveled.
REVIEW SAFETY CHECK
ON PAGE 51.
All steps must be achieved.
CARRIER INSTALLATION WITH VEHICLE SEAT BELT
Safety Check
Carrier doesn’t move more than 1" side-to-side and more than 1" front-to-back
at the belt path.
Vehicle belt is secure and untwisted.
Angle is correct when The RED line on the carrier is level with the vehicle floor.
Seating position is permitted by both UPPAbaby and your vehicle manufacturer
for use with the type of Vehicle Seat Belt.
The carry handle must be locked in the (4th) rebound position when in use.
1 2 3
To Next Page
Loading...
