18 _
Installation Precautions
09
#
It is recommended to install the device in an area with a flat surface. The ignition must be turned off while installing.
#
As the product is powered by car battery, it is required to check battery power whether the front and rear videos are
saved normally before the process of installation.
#
When installing external camera, the DC power cable must be disconnected from the main body.
#
All components required for installation are provided with the Product. Check the components and read the instructions
before installation.
#
Check if the SD Card is correctly inserted, and then connect power.
#
Do not install the product in a location that hinders your driving or road-visibility.
#
Try to conceal cables for tidiness and safety.
#
Keep the windshield clean always.
#
Install the Product in a safe and bright area.
#
When the deep color sunshade and heat lines on the rear wind shield, the rear view would be not perfectly recorded as
a normal resolution.
#
Please remove the camera’s protective plastic covers after installation.
To Next Page
Loading...
