BY UROVO PRODUCT
第六章维护以及故障排除
Chapter VI Maintenance and
Troubleshooting
简介
Introduction
本章节将阐述设备的维护方法以及故障排除方案，以帮助用户当事人更好的使用并维
护产品。
This Chapter sets forth the device's maintenance methods and troubleshooting
solutions to help users better use and maintain the product.
维护
Maintenance
为保证设备不出现故障，在使用 DT50 时应遵守下列提示：
To ensure that the device does not break down, please abide by the following
instructions while using DT50:
• 不要刮伤 DT50 的屏幕。在使用 DT50 时，请使用认可的触笔或笔尖为塑料材料
且适合用于触屏的笔。请勿使用真正的钢笔、铅笔或其他尖利物品接触 DT50 的屏幕
表面。
• Do not scratch the screen of DT50. While using DT50, please use a recognized
touchpen or any other pen which is fit for touching with point made from plastics.
Please do not use a real pen, pencil or anything sharp to touch the screen of DT50.
• DT50 的触屏采用玻璃制作。请不要让 DT50 跌落到地上或遭受强烈碰撞。
• The screen of DT50 is made from glass. So please do not make DT50 fall on the
ground or get hit.
• 避免让 DT50 承受过高或过低的温度。不要在炎热的天气将其放在汽车仪表盘上，
并使其远离热源。
• Prevent DT50 from bearing too high or low temperature. Do not put the device on
any automotive instrument panel in hot weather. Keep it away from any heat source.
• 不要在多尘、潮湿或湿润的地方使用或存放 DT50。
• Do not use DT50 anywhere dusty, dump or moist.
• 使用柔软的镜头布清洁 DT50 扫描头和摄像头。如果 DT50 的屏幕表面变脏，请
使用软布沾稀释的玻璃窗清洁溶液来清洁屏幕表面。
• Clean the scanning head and camera of DT50 by soft lens cloth. If the screen of
DT50 gets dirty, please clean the screen by soft cloth with diluted glass cleaning
solution.
To Next Page
