USC LPH800 - Page 16

Page 16
LPH800 TREATER
LPH800 MIX TANK PLUMBING
The following hoses must be connected from the Treater to the Mix Tank:
1. One hose from the supply valve on the bottom of the mix tank , to the top fitting on
the SEED TREATMENT SOURCE valve located on the front of the treater.
2. One hose from the top fitting of the valve located on the top of the mix tank, to the
left fitting on the SEED TREATMENT valve located on the right side of the treater.
3. One hose from the right fitting of the valve located on the top of the mix tank, to the
fitting on the top of the Calibration Tube.
1