Part III – Programming the System5
Page 15
6: Programming Temp Setup
If you choose Temp Setup from the Main Menu,
the Screen will display some or all of the
following choices (depending upon your system
needs).
Next to all of the choices but Temperature
Calibrate is the current programmed value for
that option. Type in the number of the option
you would like to program. The screen will
display the previous value selected and prompt
you to enter the new value. Type the new value
and Press Enter.
6a: Entering New Values for Temp Setup
For each option you select from the Temp Setup Menu the screen will display the previous value selected
for that option and prompt you to enter the new value. The following table will help you decide what
values to enter.
7: Programming Calculate LSI Setup
If you choose Calculate LSI from the Main
Menu, the Screen will display some or all of the
following choices (depending upon your system
needs).
Several variables are required to calculate the
Langalier Saturation Index (LSI). Some of these
variables are logged from various sensors, but
alkalinity, calcium hardness, and TDS must be
entered by the operator after using a test kit. If
you have a Total Dissolved Solids (TDS) test kit,
enter that variable, but if not, enter zero for TDS.
Press 0 to enter LSI parameters and 1 to enter
other parameters (Pool Size, LSI Hi band, LSI Lo
band).
Type in the number of options you would like to
program.
To Next Page
Loading...
Need help?
General