Part III – Programming the System5
Page 16
7a: Entering New Values for Calculate LSI Setup
Selecting 0 (Enter LSI parameters) displays the
following screen and prompt you to enter the
new value. The following table will help you
decide what values to enter.
Type in the number of the variable you would
like to enter. The screen will display the previous
value selected and prompt you to enter the new
value. Type the new value and Press Enter. After
you have entered all three variables, Compute LSI
and Exit will appear as an option. Select LSI and
Exit to compute the LSI.
If you are interested in how corrosive your water
may be, you may use the Ryznar Stability Index.
If the Ryznar measurement seems off, you may
want to check the Dosage Calculated.
8: Programming Sensor Wash
If you choose Sensor Wash Setup from the Main
Menu, the Screen will display some or all of the
following choices (depending upon your system
needs).
Next to each choice is the current programmed
value for that option. Type in the number of the
option you would like to program. The screen
will display the previous value selected and
prompt you to enter the new value. Type the new
value.
8a: Entering New Values for Sensor Wash
For each option you select from the Sensor Wash Setup Menu the screen will display the previous value
selected for that option and prompt you to enter the new value. The following table will help you decide
what values to enter.
To Next Page
Loading...
Need help?
General