Part IV – Routine Display
Page 29
Routine Display
The System5 routine display screen shows the
Customer Name, Location, and Rep phone
number on the facepanel as well as a special box
(the alarm scroll) for alarm messages and current
readings for the following categories:
Pressing the Setpoint Key at any time will display
the current setpoints.
Pressing the Mode Key at any time will display
the current feed modes for each pump.
Pressing the Print Key will print a status report of
the last 24 hours including data logs, alarms and
other events. NOTE: Pressing this key and
printing a special report does not replace the
normally scheduled printed data log report.
Pressing the Reset Fail/Safe Key resets all failsafe
alarms so any locked out feeders can begin
feeding again.
FCC Compliance
This device complies with Part 68 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference that may cause undesired operations.
The modem information is:
Model Number: Modem-C
Registration Number: 3Z2USA-32654-DT-E
Ringer Equivalence: 0.4B
Connectors: RJ11C/W
To Next Page
Loading...
Need help?
General