3-18
Preparation before Use > Loading Paper
Loading Paper in the Multi Purpose Tray
The multi purpose tray will hold up to 100 sheets of plain paper (80 g/m
2
).
For details of the supported paper sizes, refer to Choosing the Appropriate Paper
on page 11-16. For the paper type
setting, refer to Media Type Setting
on page 8-14. Be sure to use the multi purpose tray when you print on any special
paper.
The capacity of the multi purpose tray is as follows.
• Plain paper (80 g/m
2
), recycled paper or color paper: 100 sheets
• Thick paper (106 to 220 g/m
2
): 5 sheets
• Hagaki: 1 sheet
• Envelope DL, Envelope C5, Envelope #10 (Commercial #10), Envelope #9 (Commercial #9),
Envelope #6 (Commercial #6), Envelope Monarch, Youkei 4, Youkei 2: 5 sheets
• OHP film: 1 sheet
1
Open the multi purpose tray.
2
Pull out the support tray section of the MP tray.
If you are using a paper weight of 106 g/m
2
or more, set the media type to Thick and set the weight of the
paper you are using.
• When you load custom size paper, enter the paper size by referring to Paper Size and Media Type for the Multi
Purpose Tray (MP Tray Setting) on page 3-23.
• When you use special paper such as transparencies or thick paper, select the media type by referring to Paper Size
and Media Type for the Multi Purpose Tray (MP Tray Setting) on page 3-23.
To Next Page
Loading...
