Utopia Lustre series - 1200 Hinged Door Mirror Unit; 1200 Mirror Drawer Unit

WWW.UTOPIAGROUP.COM
page 18
Halo Units
1200 HINGED DOOR MIRROR UNIT
Mirror door can be either left hand or right hand.
Fitting the cabinet to the wall,
Remove the door from the unit, care needs to be taken due to the weight of the mirror
door panel
Note: the door hinges are fitted the reverse way to a normal hinged door (see g 2) - the
hinge back plate is fitted to the door not the unit side panel, to release the hinge and door
depress the button at the rear of the hinge body (see fig 2), to remove the door take the
weight of the door and release the hinges working from the bottom up. To re-fit start with
clipping the top hinge first.
Fit cabinet to the wall using the standard cabinet hangers which are pre-fitted to the unit
(see g 4), also see page 14 for full instructions on how to fit the wall bracket and how to
mount and adjust the cabinet.
1200 MIRROR DRAWER UNIT
Fitting this unit requires the front mirror panel to be removed from the unit, care needs to
be taken due to the weight of the mirror panel.
Remove the front mirror panel from the top and bottom drawers boxes (Note the middle
drawer stays with the front mirror panel).
Start with the bottom drawer box (g 2), Insert a cross bladed screwdriver into the catch
release mechanism on the drawer box side and turn clockwise (g 3), ensure that when
you remove the screwdriver from the catch that it remains in the open position, this may
require the front mirror door panel being pulled away from the drawer box slightly, until
the top drawer box has been released.
Once all the drawer boxes sides have been released, pull the mirror panel away from the
cabinet.
Fit cabinet to the wall using the standard cabinet hangers which are pre-fitted to the unit
(see g 4), also see page 14 for full instructions on how to fit the wall bracket and how to
mount and adjust the cabinet.
Once the cabinet has been fitted to the wall securely and adjusted, push the mirror panel
back into the drawer boxes, ensuring that the lock mechanism on each drawer box has
been fully engaged and are in the closed position,
You should hear an audible click as the catches engage, carefully pull open the mirror panel
to ensure all catches have fully engaged before passing off.
For drawer box adjustment refer to page 5 and 18.
g 1
g 1 g 2
g 2
g 3
g 4
g 3
Cabinet
Depress button to release
hinge from backplate
This drawer
box stays
with the
front mirror
panel when
removed.
Top and
bottom
drawer boxes
stay in the unit
Cabinet
INSTALLATION INSTRUCTIONS