UTT Technologies Appendix A FAQ
http://www.uttglobal.com Page 72
Appendix A FAQ
Q: How to configure your TCP/IP?
A: There are two methods of configuring TCP/IP properties: one is to manually configure TCP/IP
properties; the other is to automatically configure TCP/IP properties with DHCP. The following
describes the configuration procedure of these two methods respectively.
Method One: Manually Configuring TCP/IP
To configure the TCP/IP protocol manually, do the following:
1) On the Windows taskbar, click Start > Control Panel > Network and Connection > Local
Area Connection, right click Local Area Connection, and choose Properties.
2) In the Properties dialogue, double click Internet Protocol Version 4 (TCP/IPv4).
3) In the Internet Protocol Version 4 (TCP/IPv4) dialogue, select the Use the following IP
address radio button, Enter 192.168.1.x (x is between 2 and 254, including 2 and 254) in the IP
Address box, enter 255.255.255.0 in the Subnet Mask box, and Enter the IP address of the
Device’s LAN interface (default value is 192.168.1.1) in the Default gateway textbox.
4) Select the Use the following DNS server addresses radio button, Enter the IP address of
DNS server into the Preferred DNS server textbox.
To Next Page
Loading...