UTT Technologies Application
http://www.uttglobal.com Page 35
Key Renewal Interval: Specify how often (in seconds) the WPA group key
changes. The valid range is 60-86400 or 0, and the default is 3600. Enter 0 to
disable automatic renewal.
SSID2 Security: Select the security mode you want to use for SSID 2.
Wireless Channel: Select the frequency bands in which the wireless network works; it
provides automatic options, which means that the Device can automatically select the optimal
frequency band. The wireless devices in the same frequency band will interfere with each other.
If there are multiple wireless devices around the Device, please select a frequency band
different from that of other wireless devices when setting the channel.
Wireless Mode: Specify the wireless modes of the Device. The options are 11g Only, 11n
Only and 11b/g/n Mixed.
● 11g Only: Pure 802.11g mode, in which the maximum rate is up to 54Mbps. The wireless
clients in compliance with the IEEE 802.11g standard can be connected to the Device.
● 11n Only: Pure 802.11n mode, in which the maximum rate is up to 300Mbps. The wireless
clients in compliance with the IEEE 802.11n standard can be connected to the Device.
● 11b/g/n Mixed: The wireless clients in compliance with IEEE 802.11b, 802.11g or 802.11n
standard will be connected according to their wireless modes, with the maximum rates of
11M bps, 54M bps and 300M bps respectively.
● 11g/n: The wireless clients in compliance with IEEE 802.11g or 802.11n standard will be
connected according to their wireless modes, with the maximum rates of 54M bps and 300M
bps respectively.
Channel Width: The channel bandwidth occupied by the wireless data transmission, with the
options: Auto, 20M and 40M. Note that this parameter works only with the wireless clients
accessed using the 802.11n standard; for those using the 802.11b or 802.11g standard, only
the channel bandwidth of 20M can be used:
● Auto: If selected, the wireless clients accessed using the 802.11n standard will use the
channel bandwidths of 20M or 40M according to the results of the negotiation with the
accessed peer device.
● 20M: If selected, the wireless clients accessed by using the 802.11g standard will use the
channel bandwidth of 20M.
● 40M: If selected, the wireless clients accessed by using the 802.11n standard will use the
channel bandwidth of 40M.
Signal: Specify the strength of the wireless transmit power.
Wireless MAC: Displays the device’s physical address. We always keep it as the default value.
Enable WDS: Select to enable WDS. It can be bridging multiple wireless LAN by this function.
About more information, please refer to section:
4.6.3 WDS Configuration Example
4.6.2 5GHz wireless
On Application > Wireless > 5G Settings page, we can set 5GHz wireless parameters , including
SSID, Security mode, wireless channel, wireless mode, channel width and so on.
To Next Page
Loading...