UTT Technologies Application
http://www.uttglobal.com Page 29
Dial Type: Select the type of dial connection, available options are Always On, On Demand
and Manual.
Always On: If selected, the Device will establish a PPPoE session when starting up and
automatically re-establish the PPPoE session once disconnected.
On Demand: If selected, the Device will establish a PPPoE session only when there are
packets requesting to access the Internet (i.e., when a program on your computer attempts
to access the Internet).
Manual: If selected, you can dial or hang up a PPPoE session manually.
MTU: When dialing, the Device will automatically negotiate MTU (maximum transmission unit)
with the peer device. Please leave the default value of 1480 bytes, unless you have a special
application.
4.5.2 Dynamic IP Connection
The Dynamic Host Configuration Protocol (DHCP) is a standardized network protocol used on IP
networks for dynamically distributing network configuration parameters, such as IP addresses for
interfaces and services. With DHCP, computers request IP addresses and networking parameters
automatically from a DHCP server, reducing the need for a network administrator or a user to
configure these settings manually.
If your ISP automatically assigns an IP address, select Dynamic IP. Most cable modem subscribers
use this connection type.
To Next Page
Loading...