UTT Technologies Appendix A FAQ
http://www.uttglobal.com Page 74
Figure Appendix- 2 Automatically Configuring TCP/IP with DHCP
4) Click OK in the Internet Protocol Version 4 (TCP/IPv4) dialogue, this will return you to the
Local Area Connection Properties dialogue. Click OK again. Till now you have finished
configuring the TCP/IP properties.
Q: How to reset the Device to factory default settings?
A: When you remember the administrator password, you can go to the Application >
Configuration page, and then click OK button to reset the Device to factory default settings.
If you forget the administrator password, you can use a pin to press and hold the Reset button for
more than 5 seconds when the device is on, and then release the button. After that, the Device will
restart with factory default settings.
Note: The reset operation will clear all the custom settings on the Device, so do it with caution.
To Next Page
Loading...