CONFIGURATION/PARAMETERIZATION 71
Parameter: “VAC”
TIPS AND RECOMMENDATIONS!
Information about the VAC operation
The control system hardware DCS1 VAC (Vacuum Cleaner) is mandatorily required for
the variant.
Parameter Selection Description
VAC Check box Activate for control system type DCS1 VAC.
Required minimum
vacuum
0 ... 100mbar Minimum vacuum in vacuum cleaner system.
Max. permissible vac-
uum
0 ... 200mbar Maximum vacuum in vacuum cleaner system.
Error triggering delay 0 ... 65000ms Delay time until a failure is triggered.
Rated current 1 ... 50A/10 Max current consumption of the vacuum cleaner.
Over travel time of the
VAC after switching
the traction drive off
0 ... 65000ms Overtravel time of the vacuum cleaner after the traction drive
was stopped.
Connection error
monitoring filter not
available
Active Error monitoring filter available switching on or off.
Inactive
To Next Page
Loading...