Vahle DCS1-PCB - Page 75


CONFIGURATION/PARAMETERIZATION 73

Parameter: “Absolute value sensor”
Parameter Selection Description
Absolute values sen-
sor
Check box Activate if a absolute value sensor is used.
RS485 distance mea-
suring system (item
absolute value sen-
sor)
VahleDETO APOS Op-
tic; 8N1; VahleDETO
protocol
Selection of the distance measuring systems with RS485 in-
terface supported by the control system
SICK OLM; 9N1; binary
protocol type 2
Pepperl u. Fuchs PCV;
8E1; binary code pro-
tocol
Vahle APOS Magnetic;
9N2; steel 2 compati-
ble protocol
Leuze BPS 301i; 8N1;
RS binary protocol
Only for DCS1 variant with PCB (rail bus)
Baud rate 9600 baud Supported baud rates
19200 baud
57600 baud
62500 baud
115200 baud
38400 baud
Simulated lengths 0 ... 65000mm Lists the distance that the control system covers without
reading a bar code.