1. About this document
1.1 Version information
This document provides instructions for installing, using, and maintaining the RFL100 data
logger.
Table 1 Document versions (English)
Document code Date Description
M211861EN-D February 2020 Added content for probe splitter accessory and two probe
operation. Updated technical data chapter and the
following sections:
• Setup with one probe (page 21)
• Probe replacement (page 39)
• Info mode (page 31)
• Performing a factory reset (page 59)
Added sections:
• Mounting probes (page 28)
• Probe holder ASM213382 (page 28)
• Signal strength indicator (page 15)
• Setup with two temperature probes (page 23)
• Replacing a probe when one probe is connected
(page 40)
• Replacing probes when two probes are connected
(page 42)
• Adjustment points and requirements (page 44)
Regulatory compliance statements are now provided in a
separate document AP10 and RFL100 Regulatory
Compliances (M212235EN).
M211861EN-C February 2019 Added TMP115 probe model. Updated technical data
chapter and the following sections:
• Battery level indicator (page 12)
• Calibration and adjustment using HM40 (page 45)
• Updating RFL100 firmware (page 54)
Added sections:
• Files and folders in USB filesystem (page 18)
• Replacing a probe when one probe is connected
(page 40)
• Vaisala Insight software (page 36)
• Adjusting measurement using Insight software
(page 52)
• Performing a factory reset (page 59)
Chapter 1 – About this document
5
To Next Page
Loading...