Manual for VAKI Micro/Macro
5 Set Up
When setting up the MICRO or MACRO it is important to note the following:
The counter should be placed on a flat and stable surface.
Set the counter level by adjusting the height of the legs to ensure both fish and water are
evenly spread across the scanning area.
Ensure that the leg supports are properly secured.
Locate the counter so that the touch screen is easily accessible and not exposed to water or
direct sunlight. Note that in hot weather, high temperatures can affect the computer.
Before each count check that the mirror is completely clean and free from any stains,
residue or water droplets.
Ensure that all pipes and hoses are securely fastened.
Connect the lamp cable to lamp connection on counting head.
Connect external alarm or batch splitter to the “Alarm” port
Connect the power cable to earthed power outlet. The use of a UPS (un-interrupted power
supply) device is recommend. The counter power requirement is 80-100W.
Ensure that water and fish have a continuous free flow from the counter. Backpressure in
the pipes can overload the counter.
Take care not move or shake the counter while it is operating to protect against hard disk
failure.
To Next Page
Loading...