Table of contents
Caution / Warning
Recycling and disposal
Introduction 71.
General............................................................71.1.
Structure 92.
MCA-F..............................................................92.1.
MCA-FT............................................................92.2.
Sensor Electronics ........................................122.3.
Transmitter Central Unit (TCU) .....................122.4.
Installation 133.
General principles..........................................133.1.
Choosing the installation site.........................133.2.
Sensor dimensions.........................................173.3.
Mounting dimensions.....................................193.4.
MCA-F process coupling................................193.5.
Transmitter Central Unit (TCU) and shield.....203.6.
Electrical Connections ...................................203.7.
Valmet MCA-F Sensor Deflector Plate Installation
Guide..............................................................22
3.8.
Setting Up 234.
Mechanical Inspection....................................234.1.
Installation......................................................234.2.
Cabling Inspection..........................................234.3.
Electrical Inspection.......................................234.4.
Configuration and Calibration........................234.5.
User Interface and Operation 255.
Transmitter Central Unit.................................255.1.
Operations Menu............................................265.2.
Configuration 276.
Configuration menu........................................276.1.
Choosing and scaling the output signal.........276.2.
User Settings..................................................276.3.
Device information ........................................286.4.
Setting the date and time...............................286.5.
Address..........................................................286.6.
Calibration 297.
Sample Taking................................................297.1.
Entering Laboratory Results..........................307.2.
Offset Correction............................................307.3.
Fillers..............................................................307.4.
Calibration and sample history ......................317.5.
Diagnostics 338.
Error Table......................................................338.1.
Diagnostics Values.........................................338.2.
Diagnostics Limits..........................................338.3.
Special Functions 359.
Chemical compensation.................................359.1.
Sensitivity Correction.....................................389.2.
Recipes..........................................................399.3.
Troubleshooting 4110.
Troubleshooting.............................................4110.1.
Process Conditions........................................4110.2.
Self-diagnostics error messages....................4310.3.
Replacing Components 4511.
Sensor Electronics.........................................4511.1.
Antenna cables, Fork Sensor.........................4611.2.
Antenna Cables, FT Sensor...........................4811.3.
Antennas, Fork Sensor..................................4911.4.
Antennas, FT Sensor.....................................4911.5.
TCU ...............................................................5011.6.
Installing Vortex Cooler..................................5011.7.
HART® User Interface 5112.
About the interface.........................................5112.1.
Measurement.................................................5212.2.
Configure........................................................5212.3.
Calibrate.........................................................5312.4.
Diagnostics.....................................................5712.5.
Technical Specifications
Service kits & Spare parts
CE Declaration of conformity
Installation & Owner’s manual OUL00298 V2.3 EN
3
Valmet Mircowave Consistency Transmitter
To Next Page
Loading...
