Valmet MCA - User Manual

Valmet Microwave
Consistency Transmitter
– Valmet MCA
Installation &
Owner’s manual
OUL00298 V2.3 EN

Summary

Caution; Warning

3. Installation

3.2. Choosing the installation site

3.4. Mounting dimensions

3.5. MCA-F process coupling

3.6. Transmitter Central Unit (TCU) and shield

3.7. Electrical Connections

4. Setting Up

4.2. Installation

4.4. Electrical Inspection

4.5. Configuration and Calibration

Outlines steps for language, date/time, scaling, and calibration.

5. User Interface and Operation

5.1. Transmitter Central Unit

Describes the functions of the TCU buttons and display.

5.2. Operations Menu

Explains the structure of the operations menu and navigation.

6. Configuration

6.1. Configuration menu

Lists the available functions within the configuration menu.

6.2. Choosing and scaling the output signal

Details how to configure and scale the current output signal.

6.3. User Settings

7. Calibration

7.1. Sample Taking

Describes the procedure for taking a sample for calibration.

7.2. Entering Laboratory Results

Explains how to input laboratory consistency values.

7.3. Offset Correction

Details how to perform offset correction for measurement results.

7.4. Fillers

8. Diagnostics

8.1. Error Table

Explains how to view and interpret error messages.

8.2. Diagnostics Values

Lists and describes various diagnostic measurements.

8.3. Diagnostics Limits

Details how to view and adjust diagnostic error limits.

9. Special Functions

9.1. Chemical compensation

Temperature compensation correction curve

9.2. Sensitivity Correction

9.3. Recipes

10. Troubleshooting

10.1. Troubleshooting

Discusses Valmet MCA's self-diagnostics and common error causes.

10.3. Self-diagnostics error messages

Explains the meaning of various self-diagnostics error messages.

11. Replacing Components

11.1. Sensor Electronics

Details the removal and installation procedure for sensor electronics.

11.2. Antenna cables, Fork Sensor

Provides removal and connection steps for Fork Sensor antenna cables.

11.3. Antenna Cables, FT Sensor

Details removal and installation of antenna cables for FT Sensor.

11.4. Antennas, Fork Sensor

Guides on removing and installing antennas for the Fork Sensor.

11.5. Antennas, FT Sensor

Guides on removing and installing antennas for the FT Sensor.

11.6. TCU

Details the removal and installation of the TCU.

12. HART User Interface

12.2. Measurement

12.3. Configure

12.4. Calibrate

Describes the single-point calibration process using the HART interface.

Special Functions

Temperature Compensation Correction Curve

Sensitivity Correction

Recipes

12.5. Diagnostics

Lists and explains the functions available in the diagnostics menu.

Valmet MCA Specifications

General

Brand	Valmet
Model	MCA
Category	Transmitter
Language	English