Valmet MCA - 12.5. Diagnostics

12.5. Diagnostics
Menu information and functions:
M C A : M C A - 1 2 3 4
D i a g n o s t i c s
1 D i a g H i s t o r y
2 D i a g V a l u e s
3 D i a g A l a r m s
4 D i g i t a l I n p u t s
5 L o o p t e s t
6 C l e a r L o g s
Diag History: The 10 most recent self-diagnostics
alarms with beginning and ending times.
Diag values: Measured values of diagnostics variables
(see Chapter 8.2).
Diag Alarms: Diagnostics variables´ alarm limits;
switching alarms on and off (see Chapter 8.3).
Digital Inputs: The state of TCU binary inputs BIN0
and BIN1.
Loop test: Forcing the output signal to the desired
value.
Master Reset: Resets the TCU. Similar to powering
the TCU off, calibration is not discarded.
Status, Status nxt: State of diagnostics variables
(alarm on/off).
Installation & Owner’s manual OUL00298 V2.3 EN
57
Valmet Mircowave Consistency Transmitter