3636
Owner’s Information
Setting the time
The fi rst thing to do is to set the time.
With your thumb, hold down both the AUTO and TIMER buttons until F fl ashes.
Let go.
Note the digital clock on the bottom right hand corner. The ▲ button sets the
hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is fl ashing. If it stops fl ashing,
go back to 1.
The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the AUTO button while the display fl ashes.
Let go and wait until the fl ashing stops. The remote shows the time you set. It
also shows the current temperature.
Setting the temperature
Use this setting when you come in and want to enjoy a specifi c temperature.
Push the AUTO button until a number and F fl ash. Let go.
While it is still fl ashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your fi replace will reach that temperature and the remote will check the temperature
every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even
heat.
1.
2.
3.
4.
1.
2.
Your fi replace remote control helps you get the comfort, convenience and aesthetics you want from your gas
fi replace. The remote controls your fi replace in different ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and
automatic ON/OFF can only be programmed when the function display is fl ashing. Be patient when
programming as it can take a few seconds to set.
To Next Page
Loading...
Need help?
General
