18
Installation
Fuel Bed Support
Adjust Fuel Bed Support (if necessary)
The appliance is supplied a the fuel bed support with
an adjustable bracket already installed in a specific
position.
Unless otherwise indicated in the fuel beds’ installation
instructions, an adjustment is not necessary.*
If desirable, the position of the bracket can be changed
by releasing its 3 retaining screws, moving it as required
and tightening the screws.
Moving the bracket forward will allow more
impingement/glow/flame height; moving the bracket
backward will do the opposite.
*The adjustable bracket of the fuel bed support will
need to be replaced by a different one to install the
Traditional Logs Kit 739TLK. This bracket is included
loose with the logs or the appliance. See 739TLK
installation instructions.
To Next Page
Loading...
