4. Gently push the terminal block towards the base until it clicks.
5. Remove the Jumper 3 (see the diagram in Connecting the cables on page17). Jumper 3 is used to
determine EOL. By default the reader has EOL ON. EOL is always off in Wiegand mode.
Please note that you must set the Jumpers to configure your application. For more information on
setting the Jumpers in Wiegand mode see Setting the Jumpers for Wiegand on page21.
Mullion Reader VR20 VR50 – Installation Manual Mounting and connecting
© Vanderbilt 2021 19
A-100410-d
12.02.2021
To Next Page
Loading...
