Table of Contents
1 Introduction 5
2 Technical data 6
2 Compliance 8
2.1 IEC/EN60839-11 compliance 8
2.2 UL compliance 8
2.3 FCC statement 8
3 Safety regulations 9
4 Reader components and package contents 10
4.1 Reader components 10
4.2 Reader Components 10
5 Mounting and connecting 12
5.1 Mounting a reader 12
5.2 Mounting a reader indoors (IP54) 12
5.3 Mounting a reader outdoors (IP55) 13
5.4 Mounting a reader outdoors (IP66) 14
5.5 Mounting a reader with cables fed from the side 14
5.6 Connecting the cables 17
5.6.1 Connecting the reader in OSDP mode 17
5.6.2 Connecting the reader in Wiegand mode 17
5.7 Setting the Jumpers 20
5.8 Setting the Jumpers for OSDP 20
5.9 Setting the Jumpers for Wiegand 21
5.10 Reverse mode Wiegand 23
5.11 Programming a reader for reverse mode transmission 24
5.11.1 Reverting to standard mode Wiegand 24
5.12 Programming a Reverse mode transmission reader for 26 Bit Wiegand 24
5.12.1 Re-programming a reverse mode transmission reader away from 26 Bit Wiegand 25
5.13 Default Configuration Card 25
5.13.1 37 Bit Wiegand. 25
6 Closing the reader 26
7 Disassembling the reader 27
7.1 To disassemble the reader: 27
7.2 To remove the terminal block: 28
8 Default settings 29
8.1 3CT Tool 29
8.2 Setting burst mode using the keypad 30
9 Connecting the reader to SiPass integrated 31
To Next Page
Loading...
Need help?
General
