Vanderbilt VR50M-MF - 10.2 Setting the OSDP address for the card reader

6 Closing the reader
To close the reader:
1. Holding the front of the reader at an angle, insert the hook on the top of the base into the
corresponding slot in the front of the reader and slide down.
2. Gently press in the bottom of the reader front until the snap lock confirms a secure attachment.
3. Screw the cover screw (see number 4 in Reader Components on page10) into the bottom of the
reader.
If you are using the IP66 gasket, hold the tab at the bottom of the IP66 gasket clear of
the reader while closing.
After closing the reader, press the tab up into the correct sealed position.
© Vanderbilt 2021 26
A-100410-d
12.02.2021