8 Default settings
Setting Default
Reading MIFARE Classic UID
Reading MIFARE Plus SL1 – SL3 UID
Reading MIFARE DESFire EV1 UID
Communications mode
OSDP (to change to Wiegand mode remove Jumper 1
and Jumper 3)
Backlight Always on (change with 3CT tool)
Bus address 1 (Up to eight are supported)
Wiegand output 26/32/37/56 Bit
Wiegand key PIN burst 4/8 Bits
Light frame Follows Red, Green LED inputs in Wiegand mode
Tamper/Yellow Connection Tamper output (change to yellow LED with 3CT tool)
Wiegand heart beat mode OFF
Time-out for configuration card (keypad backlight
turns off when this timeout expires subsequent to
last keypress)
3 seconds
Activation time-out 30 seconds
Hold-off time for card read 100 milliseconds
Reception for card (time before the same card will be
detected in the field again)
Inactive
Min background illumination 12
Max background illumination 255
Off-line indication Yes
Buzzer volume for key press 2
Buzzer volume for card read 2
System sound 10
8.1 3CT Tool
To change the default configuration of the reader, use the 3CT tool. You can purchase the 3CT tool as a
separate download. You can use the 3CT tool to configure MIFARE Classic and DESFire EV1 card
formats to be configured along with Wiegand options to be used for the card readers. For further
information, please contact Vanderbilt International Ltd.. The 3CT tool configures the format in which user
cards are interpreted by the card reader. The 3CT tool supports configuration of the following
options:Tamper Output / Yellow Input and Heart beat Mode.
© Vanderbilt 2021 29
A-100410-d
12.02.2021
To Next Page
Loading...
