When the reader is first powered up, the yellow LED flashes. The flashing lights stop when it is correctly
configured to SiPass integrated. This can be tested by holding a card next to the reader. A correctly
configured reader acknowledges the card according to the SiPass integrated settings.
Please note that a new reader will always get the next free bus address. For example, if a reader with bus
address 5 is removed and a new reader is installed, the new reader gets address 5.
9.3 Connecting the reader to SiPass integrated in Wiegand mode
For more detail on connecting the reader to SiPass integrated via Wiegand see Connecting the reader in
Wiegand mode on page17.
Mullion Reader VR20 VR50 – Installation Manual Connecting the reader to SiPass integrated
© Vanderbilt 2021 32
A-100410-d
12.02.2021
To Next Page
Loading...
