MENU SYSTEM : MAPPING
4
02.9673.0001 A 22-May-01 65
DisP
Display Illumina-
tion
Accesses options for Menu Display on and off times.
DMX DMX
Accesses functions for setting DMX mode or pan/tilt options (1st level
menu) or sets starting address for luminaire in DMX systems (Addr).
Dnld Download Downloads program to luminaires.
DSEQ Delete Sequence Deletes cue sequence.
E 16 Enhanced 16-bit Configures luminaire for operation in enhanced DMX 16-bit mode.
E 8 Enhanced 8-bit Configures luminaire for operation in enhanced DMX 8-bit mode.
Edge/
EDGE
Edge Motor Specifies edge function for manual control or testing.
Enab Enable Enables a function.
Encr Encoders Accesses encoder choices for diagnostic testing.
FAIL Test Fail Indicates that sensor test has failed.
FGob Fixed Gobo Tests fixed wheel gobo function.
FHrs Fixture Hours Displays total number of hours luminaire has been powered on.
Fixt Fixture
Access luminaire specification information such as model, serial num-
ber, software version, along with status information and download func-
tion.
FLTM Follow Time Accepts value for cue follow feature.
FTim Focus Time Accepts timing value for focus time.
Gobo Gobo Select
Specifies rotating gobo select for manual control (Man) or gobo select
EOT sensor for testing (Test).
Indx Gobo Index
Specifies rotating gobo index for manual control (Man) or gobo index
EOT sensor for testing (Test).
InvP Invert Pan Reverses pan action for special focus requirements.
InvT Invert Tilt Reverses tilt action for special focus requirements.
Iris Iris Motor Specifies iris mechanism for manual control or testing.
ISEQ
Individual
Sequence
A sequence playback mode which will play the cues from each individual
luminaire, if any. (In ISEQ, if the number of cues is different, it will only
play as many as each luminaire has stored. The follow time is taken
from the master luminaire.)
ITim Intensity Time Accepts timing value for intensity fade time.
L ON Lamp is On Configures arc luminaire so that lamp will strike upon power up.
LAMP Lamp
Accesses lamp power up options and information (CFG) or sets beam
for lamp alignment adjustment (TEST).
LHrs Lamp Hours Displays total number of lamp operating hours.
LId Luminaire ID
Displays unique ID number for the luminaire which is used by Virtuoso
consoles to identify the unit (in two pages).
Table 3: Menu Function Definitions (Continued)
Display Definition Purpose
To Next Page
Loading...
