VAT 642 Series - Page 106

MAINTENANCE Series
642
106/119 Edition 2017-11-24 742280ED
Description
Required
tools
6. Remove or replace option board. (sample picture)
7. Reassemble all parts in reverse
order (see steps 6…3).
8. Tighten panel screws with 1.1 Nm
(see step 3).
9. Connect all electrical connections.
Pozidriv screw driver size1
Open end wrench 7 mm
If you need any further information, please contact one of our service centers. You
can find the addresses on our website: www.vatvalve.com.
If you need any further information, please contact one of our service centers. You
can find the addresses on our website: www.vatvalve.com.