VAT Series 651 - Page 46

Installation, Operating & Maintenance Instructions
Series 651 DN 320-400 (I.D. 12“ - 16”), Logic
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
267736ED
2008-02-26
46/53
Description Required tool
1. Remove female screw locks from POWER,
SENSOR and INTERFACE connectors.
Open end wrench 4.5 mm
2. Remove the panel screws.
Pozidriv screw driver
size 1
3. Lift the panel carefully.
4. Push the connector release (1) a little down
and disconnect fan cable (2) from option
board.
2
1