Vatech EzRay Air Wall - Cleaning Procedures; Disinfection Guidelines

7. Cleaning and Disinfection
44 EzRay Air Wall (VEX-S300W) User Manual
7.1 Cleaning
 The equipment surfaces can be cleaned with a soft cloth damped in a non-alcohol
based, non-corrosive cleaning solution. Do not use sponges or, in any case, any
material that can be reused.
7.2 Disinfection
 Use only disinfectants that comply with the valid requirements of the respective
national regulatory body or whose bactericidal, fungicidal, and virucidal properties
have been verifiably tested and approved accordingly.
 Sterilization and disinfection should be performed thoroughly for items that have
been in frequent contact with patients and operators.
 Do not use UV systems to disinfect the equipment, as exposed parts of the
device can turn yellow or discolor.
 The use of unsuitable Cleaners or disinfectant agents and methods can damage
the equipment and accessories. Only use the Cleaners or disinfectant agents
specified or approved by VATECH
 The following Cleaners or disinfectant agents have been evaluated for safe use
on the surfaces.
 Never combine products or with liquids other than the products listed above.
 Damages to surfaces and materials due to the use of different products cannot be
excluded even if they are not included in the exceptions mentioned above.
 Use a non-alcoholic chlorine dioxide-based disinfectant.
Sample